Where are the IAM settings/options?

Start
Prev
1
Next
End

Anton Driesse
Topic Author

21 Dec 2021 11:17 #10427 by Anton Driesse

Where are the IAM settings/options? was created by Anton Driesse

Sorry if I overlooked the obvious somewhere, but I can't find where to set any options related to the incidence angle modifier, such as whether AR glass is present or not, or preferably even the calculation model parameters or measured profiles. Would someone point me in the right direction?

Please Log in or Create an account to join the conversation.

pgilman

21 Dec 2021 20:57 #10429 by pgilman

Replied by pgilman on topic Where are the IAM settings/options?

Hi Anton,

I think my replies in this discussion should answer your questions:

sam.nrel.gov/forum/forum-general/2255

Best regards,
Paul.

Please Log in or Create an account to join the conversation.

Anton Driesse
Topic Author

22 Dec 2021 09:32 #10432 by Anton Driesse

Replied by Anton Driesse on topic Where are the IAM settings/options?

Here's our subsequent email exchange to save other people some searching:

On 2021-12-21 22:33, Anton Driesse wrote:
>
> Hi Paul,
>
> I followed the links, and the short answer appears to be that the user cannot in any way adjust IAM. Is this correct?
>
> Anton

On 2021-12-21 22:43, SAM Support wrote:
> Hi Anton,
> Yes, the IAM is used in different ways in different parts of the code and its parameters are not exposed to the user interface. Improving this is on our wish list.
>
> Best regards,
> Paul.

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Moderators: pgilman